table top epoxy mixing instructions

Be sure to scrape the container sides bottom and corners as you mix. If depths thicker than 18- 14 are desired multiple coats are necessary.

Superclear Table Top Directions Faq Info Superclear Epoxy Resin Systems

Before we could begin the mix the resin had to sit in hot water for 15.

. Step 8 Tape the edges to form a dam. This will help remove the drips of table top epoxy after the flood coat. The maximum depth to pour is approximately 18- 14 thick.

The mix ratio for the MAS Table Top is 1-part resin to 1-part. Some wood may take the material well in a single coat. Mixing by hand with a stir stick mix the solution for 4 to 5 minutes.

Make sure you have at least 1 of tape sticking up beyond the. Measure 1-part RESIN to 1-part HARDENER by liquid volume not weight. It is crucial that the product is measured as accurately as possible and mixed thoroughly.

A folding motion combined with stirring and scraping the mixing vessel sides will allow you to thoroughly combine the two parts. Lets walk through the entire process of using table top epoxy- starting with what comes with your order. The Table Top surface those objects need to be bonded to the surface either with Table Top Resin or craft glue.

Best results can be obtained at constant temperatures between 70F and 85F in a clean dry dust. The completed mix should then be poured into a separate container for the final pour. You must wait at least 4 to 10 hours between.

We measured and cut. The ideal working temperature is around a constant 77F. Step 1- Cut wood top for the DIY epoxy pour console table.

Table Top epoxy ﬂood coat so air bubbles wont percolate up through the curing epoxy creating cosmetic defects. Sand the top and the sides till it is smooth. Using the recommended mix ratio.

Add colorant s at this time if desired. Should be around 70F and 85F prior mixing. One thing our technicians always recommend is setting the product in warm water for a half hour to get the epoxy warm.

The mix ratio for the MAS Table Top Pro is 1 part resin to 1 part hardener 1A1B by volume or 100 parts resin to 83 parts hardener 100A83B by weight. Pour 12 to 34 of the mixed epoxy in the center of the table and spread with a. Tabletop epoxy quantities of 64-128 ounces typically require 5-8 minutes - use a timer.

Form a dam by applying clear packing tape around the edges of the table. But first we had to mix a quart of epoxy for this step. Epoxy and let it cure for 46 hours before doing the final pour.

Table Top Epoxy levels off at about a 14 inch thick. You will find it flows better and makes getting rid of air. We strongly recommend that All of these instructions are thoroughly read BEFORE working with epoxy resin.

Mix table top according to the 11 directions in a clear mixing bucket with proper 11 measurements. The material must be mixed thoroughly for at least 3 minutes. Additional coatings can be applied if a thicker level is desired.

Mix time varies by the volume of product being mixed. The ideal epoxy working temperature is about. We used two 34 plywood to make a 1-12 thick wood top.

Youll have Part A and Part B of the epoxy resin which pours at a 11. This eliminates lots of sanding. After mixing is complete allow the mix to stand 3-5 minutes and remix for approx30 seconds.

Incredible Solutions Table Top Epoxy Instructional Use How To Properly Mix Pour Epoxy Resin The Incredibles Bar Top Epoxy Epoxy